Grinding Wheel 5″ X 1/4″ X 7/8″

Applications

Safety First - Always Grind Safely 1. Always handle and store abrasives in a careful manner. 2. Always visually inspect all abrasives before mounting for possible damage in transit, storage, or prior use. 3. Always “Ring Test” the wheel by tapping gently with a light metallic implement such as the handle of a screwdriver for light wheels, or Wooden or Plastic Mallet for heavier wheels. An undamaged wheel will give a clear tone. 4. Always make sure the operating speed established for the equipment does not exceed the wheel speed. 5. Always check mounting flanges for equal and correct diameter. 6. Always use mounting blotters when supplied with abrasives. 7. Always keep work rest properly adjusted within 1/8" (3mm) of wheel face. 8. Always direct grinding sparks downward and away from the face and body. 9. Always wear protective equipment such as, impact resistant safety glasses or goggles, full face shield, safety shoes, arm guards, leather gloves and apron must be used for operator protection for all grinding operations. Always wear a respirator to avoid inhalation of dust particles. 10. Always use a safety guard covering at least one-half of the wheel diameter. 11. Always allow newly mounted wheels to run at operating speed, with the guard in place, for at least one minute before starting to grind. 12. Always observe all safety recommendations supplied by the Equipment Manufacturer. DO NOT attempt the following: 1. Do Not use a wheel that has been dropped. 2. Do Not use wheels that have been soaked in water 3. Do Not use wheels without guards for grinding or cutoff work. 4. Do Not force a wheel onto the spindle or alter the hole of size the wheel. 5. Do Not use a wheel that fits the arbor too loosely. 6. Do Not exceed maximum operation speed established for the wheel. 7. Do Not use dirty, nicked, warped or sprung mounting flanges. 8. Do Not tighten the mounting nut excessively. 9. Do Not grind on the side of the wheel unless the wheel is specifically designed for that purpose. 10. Do Not start machine unless the machine guard is in place. 11. Do Not jam work into the wheel. Let the wheel do the work. 12. Do Not apply excessive pressure. 13. Do Not stand directly in front of a grinding wheel whenever a grinder is started. 14. Do Not grind near flammable material. 15. Do Not grind or cut material for which the wheel is not designed. 16. Do Not flat grind. Minimum grinding angle is 15°. 17. Do Not use relieved or recessed flanges with threaded hole cup wheels, cone or plugs. 18. Never use a wheel or a disc that has been dropped, chipped, mishandled or appears defective.

Specifications

Depressed Center Grinding Wheels, Type 27: Without Hubs Size: 5" x 1/4" x 7/8" Max. RPM: 12,000 Grade: A24R Techniques/Tips for proper Firepower Grinding Wheels: 1. Use this method to achieve the desired aggressiveness of stock removal and quality finish - for fast material removal increase the grinding angle between the wheel and the workpiece. For blending and finishing decrease the grinding angle and apply light pressure in a fluid motion. 2. For maximum efficiency, Type 27 Depressed Center Wheels should be used with an approach angle of 30º - 35º to the workpiece. 3. Material being cut or ground should always be clamped or securely position, especially in cutting-off operations. 4. Proper machine speed is essential for maximum efficiency. Low speed causes "jumping" of the disc, and can cause the circumference to wear unevenly. 5. Only flat cut-off wheels can be brushed, not depressed center wheels. Only 7/8" arbors can be made to 5/8" - 11.

Features

Firepower depressed center wheels are fully reinforced with resin bonded aluminum oxide to ensure safety at high speed and to increase bonding and impact strength. Designed for use on air or electric powered right angle or vertical shaft grinders. Available with or without hubs.